|
Title: Dig Dug upright issues Post by: pacmanmedic on January 19, 2016, 07:50:43 PM My Dig Dug shows a bunch of garbage on the screen and says Rom 2. It will not switch out of test mode. I've replaced the Rom 2 chip and reseated it several times. I've also reflowed the solder to the socket and checked the traces with my multi-meter. I then checked my voltages at the power supply, the pcb and the edge connector and all are fine. At this point I am completely lost. Does anyone have any ideas I may have overlooked or know of someone I can send my board to to have it fixed?
Title: Re: Dig Dug upright issues Post by: iankellogg on January 20, 2016, 08:19:12 AM well its possible the socket is just bad. Those old single wipe sockets don't hold up that well.
Title: Re: Dig Dug upright issues Post by: pacmanmedic on January 24, 2016, 09:24:59 AM Thanks. Any suggestions on where I can purchase new sockets?
Title: Re: Dig Dug upright issues Post by: iankellogg on January 24, 2016, 12:15:20 PM lots of places, i even have them.
Title: Re: Dig Dug upright issues Post by: pacmanmedic on January 24, 2016, 04:29:59 PM I appreciate all the help. Love the stuff your doing with John by the way.
|